ASTM D 4565 : 2015 : REDLINE
Superseded
View Superseded by
Standard Test Methods for Physical and Environmental Performance Properties of Insulations and Jackets for Telecommunications Wire and Cable
English
04-01-2015
11-13-2020
CONTAINED IN VOL. 10.02, 2017 Defines procedures for physical testing of thermoplastic jackets and insulations on telecommunications wire and cable and testing of physical characteristics and environmental performance properties of completed products.
| Committee |
D 09
|
| DocumentType |
Redline
|
| Pages |
24
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1These test methods cover procedures for the physical testing of thermoplastic insulations and jackets used on telecommunications wire and cable and the testing of physical characteristics and environmental performance properties of completed products. To determine the procedure to be used on the particular insulation or jacket or on the completed wire or cable, make reference to the specification for that product.
1.2The test methods appear in the following sections of this standard:
| Procedure | Sections |
| Dimensional measurements of insulations, jackets, | |
| Cross-sectional areas | 9 |
| Diameters | 6 |
| Eccentricity | 8 |
| Thickness | 7 |
| Physical and environmental tests of insulation and jackets | 10 – 25 |
| Aging test (jackets only) | 24 |
| Cold bend (insulation only) | 16 |
| Environmental stress crack (polyolefin jackets only) | 21 |
| Heat distortion (jackets only) | 22 |
| Heat shock (jackets only) | 23 |
| Insulation adhesion | 19 |
| Insulation and jacket shrinkback (oven test) | 14 |
| Insulation compression | 20 |
| Insulation shrinkback (solder test) | 15 |
| Melt flow rate change—polyolefin materials | 12 |
| Oil immersion test (jackets only) | 25 |
| Oxygen induction time (polyolefin insulation only) | 17 |
| Oxygen induction time (cable filling compound only) | 18 |
| Tensile and elongation tests | 13 |
| Physical and environmental tests of insulations and jackets of completed wire and cable | |
| Cable Torsion Test | 38 |
| Compound flow test (filled core wire and cable only) | 42 |
| Corrugation extensibility test | 36 |
| Cable impact test | 33 |
| Jacket bonding tests | 29 |
| Procedure | Sections |
| Jacket notch test | 32 |
| Jacket peel or pull | 28 |
| Jacket slip strength test | 30 |
| Pressure test (air core wire and cable only) | 40 |
| Sheath adherance test | 31 |
| Water penetration test (filled core wire and cable only) | 41 |
| Wire and cable bending test | 34 |
| Wire breaking strength | 37 |
1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard, except where only SI units are given.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific caution statement see 19.1.
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.