DIN ETS 300011 : 1992 AMD 2 1996
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
INTEGRATED SERVICES DIGITAL NETWORK (ISDN) - PRIMARY RATE USER-NETWORK INTERFACE - LAYER 1 SPECIFICATION AND TEST PRINCIPLES
12-01-1998
01-12-2013
Foreword
1 Scope
2 Normative references
3 Definitions
4 Abbreviations
5 Conformance
6 Requirements
Annex A (Informative): Application of the ETS 300 011
for PTNX interconnections (leased lines)
A.1 Introduction
A.2 Layer 1 modes of operation and interface/application
models
A.2.1 Point-to-point mode of operation
A.2.2 Multipoint mode of operation
A.3 Special requirements
A.3.1 Timing requirements
A.3.2 Tolerable fitter and wander at inputs
A.3.3 Output jitter
A.4 Operation and maintenance
Annex B (normative): Application of ETS 300 011 to the
S reference point
B.1 Scope
B.2 Definitions
B.3 Conformance
B.4 Requirements
B.4.1 Timing considerations
B.4.2 Jitter, general considerations
B.4.3 Frame alignment and CRC4 procedures
B.5 Interface wiring
B.6 Loopbacks required at S reference point
Annex C (normative): Conformance test principles for
the user and the network side of the interface
C.1 Scope and general information
C.1.1 Scope
C.1.2 General information
C.1.3 Connection of the simulator to the IUT
C.1.4 Allocation of tests
C.2 Electrical characteristics tests
C.2.1 Bit rate when unsynchronized
C.2.2 Received and transmitted line code
C.2.3 Specifications at the output ports
C.2.4 Specifications at the input ports
C.2.5 Frame structure
C.2.6 Timeslot assignment
C.2.7 Timing considerations
C.2.8 Jitter
C.2.9 Tolerable longitudinal voltage
C.2.10 Output signal balance
C.2.11 Impedance towards ground
C.3 Functional characteristics tests
C.3.1 Test of signals sent by IUT
C.3.2 States-matrix at the IUT
C.4 Interface procedures tests
C.4.1 Codes for idle channels and idle slots
C.4.2 Interframe (layer 2) time fill
C.4.3 Frame alignment (without the test of
CRC procedure)
C.4.4 CRC multiframe alignment
C.4.5 CRC processing
C.5 Power feeding
C.5.1 Provision of power and feeding voltage
C.5.2 Protection against short circuit
C.5.3 Protection against overload
C.5.4 Power consumption and interchange of wires
Annex D (informative): Characteristics of loopbacks
D.1 Introduction
D.2 Characteristics of loopback at the network side
D.3 Characteristics of loopbacks for primary rate
customer installations
Annex E (informative):
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.