Standard Test Methods for Large-Scale Hydrostatic Puncture Testing of Geosynthetics

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

06-01-2024

Publisher

American Society for Testing and Materials

Committee	D 35
DocumentType	Test Method
Pages	4
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 5514/D5514M : 2018

1.1These test methods evaluate the stress/time properties of geosynthetics by using hydrostatic pressure to compress the geosynthetic over a subgrade.

1.2These test methods allow the user to determine the relative failure mode or points of failure for geosynthetics, or both.

1.3Procedures B and C incorporate site-specific soil or other material selected by the user as the test base of the testing apparatus. Procedures B and C are methods for geosynthetic design for a specific site.

Note 1:Earlier versions of this test method incorporated a ‘Procedure A’ involving manufactured test pyramids or cones as the base of the testing apparatus. This procedure was withdrawn, but the designations B and C were retained to avoid confusion on historical specifications and technical data sheets.

1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific warning statement, see Section 6.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D 7106/D7106M : 2005 : R2023	Standard Guide for Selection of Test Methods for Ethylene Propylene Diene Terpolymer (EPDM) Geomembranes
ASTM D 6434 : 2012 : R2018	Standard Guide for the Selection of Test Methods for Flexible Polypropylene Geomembranes
ASTM D 6455 : 2011 : R2018	Standard Guide for the Selection of Test Methods for Prefabricated Bituminous Geomembranes (PBGMs)
ASTM D 4439 : 2024 : EDT 1	Standard Terminology for Geosynthetics