1 - AS/NZS 3200.2.35:1999 MEDICAL ELECTRICAL EQUIPMENT - PARTICULAR REQUIREMENTS FOR SAFETY-BLANKETS, PADS AND MATTRESSES INTENDED..
4 - PREFACE
7 - CONTENTS
9 - INTRODUCTION
11 - SECTION ONE GENERAL
11 - 1 Scope and object
12 - 2 Terminology and definitions
14 - 3 General requirements
14 - 5 Classification
14 - 6 Identification, marking and documents
16 - SECTION TWO ENVIRONMENTAL CONDITIONS
16 - 9 Removable protective means (not used)
16 - 12 (not used)
17 - SECTION THREE PROTECTION AGAINST ELECTRIC SHOCK HAZARDS
17 - 17 Separation
17 - 19 Continuous LEAKAGE CURRENTS and PATIENT AUXILIARY CURRENTS
18 - SECTION FOUR PROTECTION AGAINST MECHANICAL HAZARDS
18 - 21 Mechanical strength
19 - SECTION FIVE PROTECTION AGAINST HAZARDS FROM UNWANTED OR EXCESSIVE RADIATION
19 - 36 Electromagnetic compatibility
19 - SECTION SIX PROTECTION AGAINST HAZARDS OF IGNITION OF FLAMMABLE ANAESTHETIC MIXTURES
19 - SECTION SEVEN PROTECTION AGAINST EXCESSIVE TEMPERATURES AND OTHER SAFETY HAZARDS
19 - 42 Excessive temperatures
20 - 44 Overflow, spillage, leakage, humidity, ingress of liquids, cleaning, sterilization, disinfection and compatibility
21 - 46 Human errors
21 - 49 Interruption of the power supply
21 - SECTION EIGHT ACCURACY OF OPERATING DATA AND PROTECTION AGAINST HAZARDOUS OUTPUT
21 - 50 Accuracy of operating data
24 - 51 Protection against hazardous output
25 - SECTION NINE ABNORMAL OPERATION AND FAULT CONDITIONS; ENVIRONMENTAL TESTS
25 - 52 Abnormal operation and fault conditions
29 - SECTION TEN CONSTRUCTIONAL REQUIREMENTS
29 - 54 General
31 - 56 Components and general assembly
32 - 57 MAINS PARTS, components and layout
33 - 59 Construction and layout
43 - Appendix L - References Publications mentioned in this standard
44 - Annex AA - Rationale to particular subclauses
49 - Annex BB - Determination of the lagging material
50 - Annex CC - Procedure for determining whether a HEATING DEVICE provides HIGH or LOW HEAT TRANSFER from the heat source to the con
52 - Annex DD - Procedure for determining whether a HEATING DEVICE provides HIGH or LOW HEAT TRANSFER from the contact surface to the
53 - Annex EE -CONDITIONS OF ADEQUATE HEAT DISCHARGE